Control WLED With TitanGo via Artnet

[Jonathan Simon]

Hello everyone,

I have an Avolites Editor Key and use the Titan Go software. The goal is to control WLED (ESP32) via Art-Net from Titan.

My setup:

Titan Go + Editor Key

DMX settings:

Art-Net set to broadcast

Universe 1 → Line 1

Fixture: Generic RGBW

Network: standard LAN, everything in the same subnet

Issue:
I am unable to get Art-Net from Titan into the network.
I can't see any data in the WLED interface or with an Art-Net monitor.

To double-check, I used the Art-Net module from Bitfocus Companion – it works immediately, and WLED responds correctly. So the network, IP address, and universe assignment should be correct.

Hence my questions:

Are there any restrictions on Art-Net output with Titan Go + Editor Key?

Does Art-Net or the DMX output need to be activated somewhere else?

Is Art-Net only sent when an active playback/fader is running?

Are there any known stumbling blocks with broadcast vs. unicast in Titan Go?

Maybe I'm overlooking something obvious.
Thanks in advance for your help and experience reports!

[icke_siegen]

It sounds like you have covered all the major points. However:

• In Titan go to System mode, DMX-Settings. Left, at the Art-Net module, click on the little cog, and check that Art-Net is activated ('DMX Output' enabled) and assigned to the correct network interface
• you mentioned 'standard network', I suppose this is wired. If you are using WiFi then you defo need to enable Art-Net as described above as this is disabled over WiFi by default
• it is worth to check the firewall again. As a starting point you may disable it altogether - and if this fixes your issue then adjust the firewall by setting the rules