Avolites Pearl 2008 - URGENT! Color Palette problem!

Questions or discussions about the Titan and classic consoles and software.

Moderator: Moderators

SJPMC
Posts: 21
Joined: 26 Aug 2017, 12:29

Avolites Pearl 2008 - URGENT! Color Palette problem!

Postby SJPMC » 26 Aug 2017, 12:34

Hello,

I'm about to run a show and I'm farely new to Avolites, and we only use Beams and Wash's, the old LD had the board setup so that a color palette would change the color for either the Beam or Wash, the color values do not match so, I can't just select all fixtures and change the color wheel, how do I make this back to a palette affecting both fixture types color wise even though the color values dont matchup.

Sorry for the crude english but this is very urgent.
User avatar
niclights
The eManual
Posts: 4461
Joined: 24 Sep 2004, 01:06
Location: UK

Re: Avolites Pearl 2008 - URGENT! Color Palette problem!

Postby niclights » 26 Aug 2017, 13:32

You should be able to record values for the two types of fixtures into the same palette. So select fixture type 1, set colour, record palette (double-tap to merge), select fixture type 2 and repeat.
SJPMC
Posts: 21
Joined: 26 Aug 2017, 12:29

Re: Avolites Pearl 2008 - URGENT! Color Palette problem!

Postby SJPMC » 27 Aug 2017, 14:17

Sorry, but I didn't understand the double tap part, so, I select fix1 set the color to , for instance, red, store the palette into a flash, than, select red on the other fixture and hit, store palette and doubletap the flash where the previous one was?
User avatar
niclights
The eManual
Posts: 4461
Joined: 24 Sep 2004, 01:06
Location: UK

Re: Avolites Pearl 2008 - URGENT! Color Palette problem!

Postby niclights » 27 Aug 2017, 15:22

Yes. Sounds about right to me. Save the show if you're worried then try it. If there's a problem just reload the original show.

Who is online

Users browsing this forum: No registered users and 14 guests