Hi All,
I'm new to visualiser, I have a Pearl 2004 connected to my PC directly using the Visualiser port on the back of the Pearl. I also have a dongle installed which is working.
I tried loading the demo theatre into visualiser and the console, I set visualiser to run and selected RS-232, I have also set the console MIDI setting to Visualiser in user settings.
I have also tried building my own theatre but again it doesn't talk to desk....what am I doing wrong!!
John Huson
Pearce Hire
Communications Issue
Moderator: Moderators
-
- Posts: 9
- Joined: 17 Feb 2005, 15:57
-
- Posts: 9
- Joined: 17 Feb 2005, 15:57
Hi John,
Just out of curiosity, did you assume that your first Pearl was at fault or do you know for sure (by having run the MIDI tests)?
I had similar problems and both desk and PC were OK, but I still had to use ACDI to get them to talk.
If you haven't seen it, the document below is quite useful...
http://www.avolitesdownload.com/Downloa ... dcheck.doc
Regards,
Andy
Just out of curiosity, did you assume that your first Pearl was at fault or do you know for sure (by having run the MIDI tests)?
I had similar problems and both desk and PC were OK, but I still had to use ACDI to get them to talk.
If you haven't seen it, the document below is quite useful...
http://www.avolitesdownload.com/Downloa ... dcheck.doc
Regards,
Andy
Who is online
Users browsing this forum: No registered users and 24 guests