I have a Pearl 2008 with the unsuccessful license, have the serial number, do not think the id of the console
help
Pearl 2008 license help
Moderator: Moderators
-
- Posts: 1090
- Joined: 02 Jul 2010, 10:29
- Location: Siegen, Germany
- Contact:
Re: Pearl 2008 license help
You should be in touch with repairs[@]avolites.com
While normally you need to apply for a licence online, that online form was not functional a few weeks back, dunno if it's back okay now. So, please write to repairs, and they will sort this out for you. Or call +44 208 965 8522 during office hours.
While normally you need to apply for a licence online, that online form was not functional a few weeks back, dunno if it's back okay now. So, please write to repairs, and they will sort this out for you. Or call +44 208 965 8522 during office hours.
Re: Pearl 2008 license help
Hi, My Avolites Pearl 2008 was stuck on "Energising the Pearl". I replaced a RAM module and now is running but i have Invalid License.
I put PRLAVOS.DAT on an usb and i selected "Run to System = License" but now i'm stuck on Searching the drives... Looking for file PRLAVOS.DAT. What is the next step? I've read that i need the console ID to request a license but i cannot enter to the Service menu (i cannot use any key to enter to the menu cause the desk is not licensed). Thanks!
I put PRLAVOS.DAT on an usb and i selected "Run to System = License" but now i'm stuck on Searching the drives... Looking for file PRLAVOS.DAT. What is the next step? I've read that i need the console ID to request a license but i cannot enter to the Service menu (i cannot use any key to enter to the menu cause the desk is not licensed). Thanks!
Re: Pearl 2008 license help
You could try putting the AVOS jumper on the motherboard to start the console up into AVOS service mode. Alternatively contact Avolites service, +44 (0) 208 955 9232, for support.
Re: Pearl 2008 license help
Ok' i will try it, thanks!
Re: Pearl 2008 license help
I had to format the pen again and replace the two files prlavos and prlflash...i think were corrupted. I did it and now is running.
Who is online
Users browsing this forum: No registered users and 8 guests