Pearl Expert - Titan - DMX cards

[mezzanine]

New to the forum, not new to Avo's

The club I work in has an Expert, upgraded it to Titan last year, and after a few hurdles, is now running 7.4 - being a nightclub, the console has had it's share of patron drink baths, due to our tech position only being raised from the dance floor by 16". Anyhoo...

I normally only use universes 1 & 2, but brought some extra strobes in and patched them to an empty universe (3), set them up, and went to program them in - no data. Swap to 4, no data. Universes 1 & 2 are working fine. I open the desk, and the offset blinking green/yellow LEDs, are blinking together. All other sets of LED's are offset blinking.

I pressed reset on the DMX board, same thing - the LED's blink together, and no output.

Has the DMX card failed, and now needs repair/replacement? Any ideas are greatly appreciated. Thanks!



Robert

[niclights]

Are the output nodes assigned to lines in DMX Settings?

[mezzanine]

Yep - they're all assigned, 1 to 1, 2 to 2, and so on.

I know when the LED's blink in sequence, they're working - but the green/yellow LED's are blinking together.

[niclights]

Does it show up in Usb Expert Console at all? If so what is the status?