The Avolites Discussion Forum

Hello, I have been playing with the visualizer and simulator for the last 2 weeks. I thought i could figure it out, i even managed to get our generic R,G,B,W lights working with the 3 colors and the white using 15 degrees offset... 2 overlapped fixtures on on the same Chanel. This basically fixed the 3 color problem. I now have a 4 color light in the VIS...

so, with this dedication I'm finally coming for help.

all the lights are generic Chinese and i can not get the vis to work with the robots. I'm using a MHLED60D.

The personality files were constructed by manually. I was able to import them in to the personality builder and export the .R20 and .VIS files.

The only thing i can get working is the pan/tilt. the rest of the functions do not work.

can you please advise some help with the .vis files.

i have attached the files here on the post.

here is a quick look at the Channels :



thank you!!!! ~Russ Gries

attached is more details of the fixture

this is a XPS Document (.xps)

the only way i could get it extracted and uploaded to the forums. ( pdf was to big)

thanks, ~Russ Gries

Seems the problem is in your Vis file. See this section:



If you replace the 'Black' with other valid colour names, probably it will work.

Thanks for the reply. I did already try this with no luck.

any other thoughts?

~Russ

That is all you need to do.

It should look something like this:



Note that the r20 file must be placed in the visualiser/personalities folder. The Vis application must be restarted to see any changes to files and fixtures need to be repatched.

thanks for the reply. I added the colors,

It now looks like this:



one thing i did figure out was that the strobe was part of the problem.



so i had to set it above 31 before it would work.

so i now have the colors working. with the strobe turned on The only one that is not working is Rainbow. It just shows up as white?

Thanks for your help

~Russ

For the rainbow you would need a section like


and you need to remove the line

from the Color Wheel Section/Vismode Value.

The difference is the Vismode: speed takes a number for 'revolutions per minute'. You may find all those definitions in the manual at http://www.avolites.com/Portals/0/Downl ... Manual.pdf

As for the Strobe, the personalities reflect the dmx layout in the manual. Maybe you should set the locate value of the strobe channel to 'Open' in the d4 file.

got it,

now i have a lot more stuff not working... I'm willing to figure it out but is there a manual where i can see what each gobo looks like?

so for instance, a picture and a term so i can add the correct goboes with light i have?

right now there just random and not correct with my real goboes. although they do work... its not very helpful... i would like them to match.

the viswiz manual will help! thanks.

~Russ

http://www.avolites.com/Portals/0/Downl ... 20Info.pdf

You'll find the gobo thing has very limited functionality. That's why usually we use 'Number One', 'Number Two' and so forth. If i remember corectly, some folks have posted some gobo info here in the forum some years ago.