Page 1 of 1

Communications Issue

Posted: 17 Feb 2005, 16:03
by Pearce Hire
Hi All,

I'm new to visualiser, I have a Pearl 2004 connected to my PC directly using the Visualiser port on the back of the Pearl. I also have a dongle installed which is working.

I tried loading the demo theatre into visualiser and the console, I set visualiser to run and selected RS-232, I have also set the console MIDI setting to Visualiser in user settings.

I have also tried building my own theatre but again it doesn't talk to desk....what am I doing wrong!!

John Huson
Pearce Hire

Posted: 17 Feb 2005, 16:42
by Pearce Hire
OK, cracked it! It would appear that the Visualiser port on one of our Pearl 2004's doesn't work!

Tried another one it's fine!

Posted: 17 Feb 2005, 19:49
by iadwm
Hi John,

Just out of curiosity, did you assume that your first Pearl was at fault or do you know for sure (by having run the MIDI tests)?

I had similar problems and both desk and PC were OK, but I still had to use ACDI to get them to talk.

If you haven't seen it, the document below is quite useful...

http://www.avolitesdownload.com/Downloa ... dcheck.doc


Regards,

Andy