.viz for Martin MX-10? Making my own?
Posted: 13 Oct 2008, 18:01
Hi All,
I have an event coming up in the next few weeks for which we will be hiring a pear. As I haven't used one for a long time and will only have a day to re-aquaint myself, I am keen to do some pre-programming using the simulator.
The rig will have a fair number of Martin MX-10 scanners, however I have been unable to find a .viz file for these, although there is a personality in the pearl.
Is there anywhere I can get one from, or alternatively make my own? I have seen mention of the "VizWiz" what is that and where can you get it from?
I also noticed that the Mac250 Entour's do not have gobo's just the numbers, is there any easy way to update these with actual gobos?
Finally! sorry, loads of questions, if none of this is possible, is there any way to interface the pearl simulator with another viz program over ACDI or similar, without a dongle?
Any help would be very much appreciated.
Kind regards
Ben
I have an event coming up in the next few weeks for which we will be hiring a pear. As I haven't used one for a long time and will only have a day to re-aquaint myself, I am keen to do some pre-programming using the simulator.
The rig will have a fair number of Martin MX-10 scanners, however I have been unable to find a .viz file for these, although there is a personality in the pearl.
Is there anywhere I can get one from, or alternatively make my own? I have seen mention of the "VizWiz" what is that and where can you get it from?
I also noticed that the Mac250 Entour's do not have gobo's just the numbers, is there any easy way to update these with actual gobos?
Finally! sorry, loads of questions, if none of this is possible, is there any way to interface the pearl simulator with another viz program over ACDI or similar, without a dongle?
Any help would be very much appreciated.
Kind regards
Ben