Hi All,
I have an event coming up in the next few weeks for which we will be hiring a pear. As I haven't used one for a long time and will only have a day to re-aquaint myself, I am keen to do some pre-programming using the simulator.
The rig will have a fair number of Martin MX-10 scanners, however I have been unable to find a .viz file for these, although there is a personality in the pearl.
Is there anywhere I can get one from, or alternatively make my own? I have seen mention of the "VizWiz" what is that and where can you get it from?
I also noticed that the Mac250 Entour's do not have gobo's just the numbers, is there any easy way to update these with actual gobos?
Finally! sorry, loads of questions, if none of this is possible, is there any way to interface the pearl simulator with another viz program over ACDI or similar, without a dongle?
Any help would be very much appreciated.
Kind regards
Ben
.viz for Martin MX-10? Making my own?
Moderator: Moderators
Wow, complicated isn't it!, I am surprised that there isn't an MX-10 one already.
With regard the gobo's I have seen some mention on these boards of some ready made gobo's for some fixtures, are these available from anywhere? I tried downloading the update from the personalities site, but to no avail.
Also, I presume that when the manual says that the "solid mode is not fully implemented", this means it isn't working at all? I get nothing but a black page.
Finally, re: the ACDI with other applications, I presume that one can ignore the warnings re: dmx outputs that come up in the simulator then?
Apologies for all the questions.
Kind Regards
Ben
With regard the gobo's I have seen some mention on these boards of some ready made gobo's for some fixtures, are these available from anywhere? I tried downloading the update from the personalities site, but to no avail.
Also, I presume that when the manual says that the "solid mode is not fully implemented", this means it isn't working at all? I get nothing but a black page.
Finally, re: the ACDI with other applications, I presume that one can ignore the warnings re: dmx outputs that come up in the simulator then?
Apologies for all the questions.
Kind Regards
Ben
Who is online
Users browsing this forum: No registered users and 4 guests