The Avolites Discussion Forum

always on relay curve... is this even the case when i press clear?
and if it does go off, is there a way to stop it from doing so?

and i apologise if this is obvious

Hi,

With the always on relay curve, the output for that channel should be 255 regardless of the input level. The clear button usually sets the level to 0 however after the curve is applied this still gives an output of 255. As far as I am aware the dimmer should not go off for any reason with that curve applied.

thanks. I want to be sure before i get stuck in the situation.

i have to supply moving light power via Str**d contactors (long story!) and i really can't have them going off every time i press clear!

If you use this curve the desk will always keep the channel at full. It should not go off so that is fine.

I think more problematic is your choice of dimmer

oh I know. I know!