diamond 4 relay question - maybe a dumb one

[new13dad]

always on relay curve... is this even the case when i press clear?
and if it does go off, is there a way to stop it from doing so?

and i apologise if this is obvious

[Gregory]

Hi,

With the always on relay curve, the output for that channel should be 255 regardless of the input level. The clear button usually sets the level to 0 however after the curve is applied this still gives an output of 255. As far as I am aware the dimmer should not go off for any reason with that curve applied.

[new13dad]

thanks. I want to be sure before i get stuck in the situation.

i have to supply moving light power via Str**d contactors (long story!) and i really can't have them going off every time i press clear!

[Olie]

If you use this curve the desk will always keep the channel at full. It should not go off so that is fine.

I think more problematic is your choice of dimmer

[new13dad]

oh I know. I know!