When entering a value directly (using <@Wheel> value <Enter>) for Shape Speed, the value may be processed as being of some unit type other than that of the type being displayed.
Repro as follows -
1. Start new show
2. Patch 1 x Dimmer
3. Select Dimmer fixture
4. [Shapes And Effects][Shape Generator][Create][Dimmer][Dimmer Spread]
5. Note - Wheel View @A shows Shape Speed parameter value in BPM
6. <@A> 120 <Enter>
7. Observe, Wheel View shows Shape Speed to be 0.50BPM
Any value entered should be processed as being of the same unit type as the value being displayed unless the operator explicitly chooses some other unit type from the soft options.
Questions or discussions about the Titan and classic consoles and software.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests