Is there some way to fan/spread an attribute value across multiple fixtures via command line syntax? As a quick example, if I have a bunch of dimmers selected in the programmer, the Intensity attribute bank is on with Dimmer on wheel A, and I wanted to fan the dimmer values starting at 5% on the first dimmer and ending at 100% on the last dimmer I was expecting the following syntax to work
Code: Select all
<@A> 5 <Through> 100 <ENTER>
I also tried from both the programmer and view cue windows to block select the attribute column then
Code: Select all
5 <Through> 100 <ENTER>
Also tried selecting just the actual attribute cells rather than block selecting by pressing the column header but none of these attempts worked.
In the end I had to whip out a calculator for all the spreads I wanted to achieve and workout the mid point with
Code: Select all
(range max - range min) / 2 + range min
Then set the attribute level to that mid point and with all fixtures selected hit <Fan> then dial the first fixture down to the range min value. But can't shake the feeling that there is an easier way to do this?