Hello friends.
I am currently pre programming for a festival on my Avo Pearl Expert Titan V8 and was wondering if anyone could help me with this,
I'm trying to record positions by running a shape then stopping it at a good position by having it assigned to a rate master but when you run a shape the pan and tilt values don't seem to change in the programmer so I can't record the created position into my pallettes.
Any ideas?
Chur
Recording positions from Shapes Engine
Moderator: Moderators
-
- Posts: 2
- Joined: 21 Oct 2017, 23:14
Re: Recording positions from Shapes Engine
Unfortunately this isn't currently possible but it has been mentioned recently and I can see how it would be useful so hopefully it might be possible in a future version.
Who is online
Users browsing this forum: No registered users and 50 guests