Hey guys,
how do I connect my Tiger Touch console to the Lightconverse Software.
Thanks
Link Tiger Touch to Lightconverse
Moderator: Moderators
Re: Link Tiger Touch to Lightconverse
You will need to connect your tiger touch to the computer running light converse using a cat-5 internet cable.
then in the tiger touch go to setup (avo key + disk) then to dmx settings, and then the computer should show up in the artnet area, add that to the desired line and then you just need to change the artnet setting in lightconverse (which i don't know how to do, google it)
then in the tiger touch go to setup (avo key + disk) then to dmx settings, and then the computer should show up in the artnet area, add that to the desired line and then you just need to change the artnet setting in lightconverse (which i don't know how to do, google it)
- zahoorjury
- Posts: 145
- Joined: 23 Aug 2007, 00:20
- Location: karachi,pakistan
Re: Link Tiger Touch to Lightconverse
So you mean that we patch laptop and TT together without any other hardware in the middle , like an Artnet device or like somethings else?
- zahoorjury
- Posts: 145
- Joined: 23 Aug 2007, 00:20
- Location: karachi,pakistan
Re: Link Tiger Touch to Lightconverse
And can we send TT Dmx out command via Artnet cable to a lightning software without using any other device in the middle, just a single cable ?
Re: Link Tiger Touch to Lightconverse
It usually works best if there is a network switch (or router) between the two.
Who is online
Users browsing this forum: No registered users and 16 guests