The Avolites Discussion Forum

I'm trying to patch this led wash strip into a show.

I have found the personality for it and it seems to work OK, but when I set up a state and attach it to a playback, it will trigger into action ok from the fader, but taking the fader down will not turn it off again. I assume this is because it does not have a true dimmer attribute as such.

Could anyone suggest how I should set it up so the fader turns it on AND off?

This is on a Titan one.

New to this, so any help appreciated.

Press the 'playback options' softkey, click your playback, chose 'release mask', set it to 'local' and then toggle color so it 'includes color'.

Thank for that, will give it a try.

A lot to learn...

Release will only make it return to the previous active state/palette or locate values.

If you want to fade LTP channels by fader you need to set the playback to mode 2 via [Edit Times]. Normally any RGB fixture without a dimmer will have a virtual dimmer assigned so this should not be necessary. However, in the case of multi-cell fixtures where there is a master dimmer but no cell dimmers there will not be a virtual dimmer on the individual cells.