The Avolites Discussion Forum

Hi, my pearl 2010 has a usb port in the front for saving and loading data (normal)
but it also has a port for a usb cable in the back of the console

where is this used for ?

Hi there
Can you pm me the serial number of your console, I can then guide you better
Thanks

Hi!

I have the same questions, apart from the picture in this thread that is from a pearl clone due to the 3pin dmx...

but my sapphire 2000 does have the same usb jack?


I have tried searching the manual without luck

The port was put in so that it could be implemented later however no software was ever released that made use of that port.

Ric wrote:Hi there
Can you pm me the serial number of your console, I can then guide you better
Thanks

Hello ,
The serial number of My Pearl 2010 is 8532.
I think it's the BORIS 3 Mother board.
what is the possible fonction for the famous rear usb connector?
Best regards

Gregory wrote:The port was put in so that it could be implemented later however no software was ever released that made use of that port.

This is still the case, the classic Pearl software is no longer being actively developed, the focus is now solely on the Titan platform.

Gregory wrote:

Gregory wrote:The port was put in so that it could be implemented later however no software was ever released that made use of that port.

This is still the case, the classic Pearl software is no longer being actively developed, the focus is now solely on the Titan platform.

It's realy domage because i just bought a Pearl 2010 and it's a very expansive .
I hope connect the Pearl simulator like à synchronise console with the Pearl 2010!

The Pearl expert is Now out of m'y distributeur catalogue ...

Thanks for your answer.
Best regards