The Avolites Discussion Forum

Hi

Have a problem with the programming!

When I make a shape..... type Tilt Swing
When I turn on cue, so JUMP luminaires to a position, it will be the same when I shut down cue. Then JUMP luminaire to the starting position

How a do a soft start to the fixture starts stylish at position and ends in the same starting position??

I hope you understand my problem on my bad English

Just set a fade in and fade out time.

I try!

If i have high speed on the shape
When i start the Cue its start slowly to right speed! When i stop the cue its slow down AND JUMP TO THE POSITION

Make sure playback is set to mode 1 or it will only fade in.

Will double check and test some

thanks