The Avolites Discussion Forum

It worked yesterday, and I tried going back to the same show file from disk (yesterday).. but now:

* I can't push the up/down arrows for the playback pages, I have to hit the number and manually type a page I wish to go to.
* I can't change phase/size/offset etc of shapes.. my mouse's scroll wheel does nothing, left clicking does nothing..

I open the same show in titan1 and all works fine, but i'm wanting to use titan sim..

any suggestions if a problem occurs that isnt in a show file?

Thx

As far as I am aware the page up/down touch areas are not yet implemented in the simulator. Neither is mouse wheel -> FX parameters. Currently to page up/down in the simulator you can use the dedicated keys on the virtual panel. To adjust FX parameters use the wheels in virtual panel or input numerically. In T1 you can use the touch page up/down as there are no equivalent buttons. In T1 mouse scrolling of FX paramters only works if you hover over the associated thumb wheel which is not present in the virtual panels (since they have full size wheels).

my bad, your quite right. i guess i was going back/forth between T1 and sim too often!