Page 1 of 1

Pearl 2008 Licence error

Posted: 19 Jun 2011, 23:42
by Adamastor
Hi,


Yesterday when I turn on my desk, everithing were OK, but after a Wipe All, a licence error apears in the screen don't leting me do nothing!!


I don't remember very well what was the message, but it was samething like turning the key to program to enter the licence key, or turn the key to run to leave the message


What can I do??

Posted: 20 Jun 2011, 07:06
by niclights
See here

However, if it is an emergency I would contact service directly, preferably by phone.