The Avolites Discussion Forum

Just wondering if it is possible to perform repeated scheduled tasks over the period of a week using internal timecode on the Pearl Expert running Titan v4.0


Equipment

6 x Vl3000s
1 x Pearl Expert c/w Titan v4.0


Fixtures will be installed for the period of one week and be projecting custom gobos doing various stuff on an architechtural installation. I would obviously like to lamp the fixtures on and off at the same time each evening and morning, respectively. Obviously it will be an unmanned operation.

I am planning to run the cue stack's using internal timecode. Is it possible to record lamp on/off in to the cue stack and repeat this process for the entire week.

If you have any suggestions or improvements to this concept I would be most gratefull

Kind Regards


[/u]

You can't record fixture macros into cues but you can always reproduce their action.

For the VL's you just need to set the control channel to 'lamp on'/'lamp off', hold that cue for at least 3sec and then return it to 'safe'.

Much appreciated,

Cheers