Azure 2000/Shadow repatch fixtures causes TILT ERROR
Posted: 08 Dec 2010, 08:28
hi Avo fans,
I have a question (or a bug?)
I tried to move a fixture from DMX output A to B and that works fine.
I mean that it DOES react on my previously programmed moves, dimmer fader, colour presets and chases.
But 1 thing i found very strange.
It appears that the TILT function is totaly confused.
I have only 2 positions left when i want to make a position.
1 or 255, every value between that does nothing to the fixture.
I'm not sure about the next thing but i thought i did a repatch before but then from DMX A to C (same IC?) and that worked fine but i haven't tried that again, so Ã'm not 100% sure about this.
Does anyone recognize this problem ??
thanks !!
I have a question (or a bug?)
I tried to move a fixture from DMX output A to B and that works fine.
I mean that it DOES react on my previously programmed moves, dimmer fader, colour presets and chases.
But 1 thing i found very strange.
It appears that the TILT function is totaly confused.
I have only 2 positions left when i want to make a position.
1 or 255, every value between that does nothing to the fixture.
I'm not sure about the next thing but i thought i did a repatch before but then from DMX A to C (same IC?) and that worked fine but i haven't tried that again, so Ã'm not 100% sure about this.
Does anyone recognize this problem ??
thanks !!