The Avolites Discussion Forum

Dear fellow knob-pushers

I have a problem with a pearl.
When i make chase it al goes well. After programming pushing the fader up the chase starts as it should.
When the fader goes down it the chase stops as it should.

And now the funny part starts:

When i push the fader up again the chase doesn't start untill i hit go!

I went through every menu available, re-installed the software.
Nothing helps!

Is there anyone who knows this problem or a way to fix this??

Thanks in advance!

Greetz, Dennis

This sounds like the chase might be set to 'fader stops, go to start'.

Program mode.
Fire chase.
[Chase Parameters]
[More...]
Toggle softkey A until it reads [fader will reload chase].

See if that helps.

Thanks for your reaction!

Already found that function, but that doesn't seems to be the problem.
It's on "fader will reload chase".
That's the weird part.

Any other thoughts?

Unfortunately not. This is one of those things that sounded vaguely familiar but I was hoping it was the chase option above.

Does it only happen with one chase or all? If it's only one can you re-record it and see if it is ok on the new version?

It's in every chase i build.
So i still think (and hope) it is a software thing.