Page 1 of 1

Azure Graphics Tablet Cable

Posted: 15 Aug 2010, 08:25
by branden_aus
Hey we have recently purchased a second hand 1212HR III, and as it has the Cat5 connector we need to make a converter from Cat5 to Serial, we are wondering if there is any illustration online on a cable pinout diagram so we can make one of these cables? Why is it not available under illustrations as it is now a discontinued item?

Posted: 18 Aug 2010, 11:12
by branden_aus
has anyone had a chance to look at this yet? It would be useful if i could have it for the weekends show, so i can test out the tablet and give our Azure a new lease of life.

Posted: 18 Aug 2010, 13:54
by niclights
Have you tried contacting service about this? You could also try sending a pm to Andy who I think might know the pinouts.

Posted: 18 Aug 2010, 14:55
by EmmaThompson
If you email i will send you all the info we have regarding this.

Lee in service.

Posted: 19 Aug 2010, 00:44
by branden_aus
hey thanks for that, the only issue i have is that they are all serial connectors for the Tablet side, our tablet is the newer cat5 version any ideas on how this may work? Ive seen other people on the forum with the same version as us the 1212HRIII. ANy ideas??? thanks

Posted: 20 Aug 2010, 03:51
by iadwm
Did you get the pinout info?

I did look but couldn't find the original details I had and I sold my graphics tablet when I moved over to Expert.
I'm sure I was sent a link by Alwyn to page that wasn't visible to the public (?), but I might be making things up again.....