The Avolites Discussion Forum

Hi.

I've tried to make the fader take contol of ex. radius of a circle. didn't manage it.

This can be done in an easy way, I've heard, but how?

Thanx,

K. Ivar Skjorestad

Create the shape and store on a Playback

In Program Mode:
[Shape Generator]
[Playback Parameters]
Hit Playback Swop button of shape
Hit [Toggle Size] Softbutton until display reads Size is Timed.

This should automatically set Playback to Mode 2.

That's it!

You can also use these 'timed' parameters with an LTP fade time to fade in a shape.

Hope that helps.

Nic

Hi, could you tell me how to make a Fader controlling the Shape Speed on AZURE?

Thanks

Same as above, except you want to toggle speed until it reads 'timed'.

Remember the fader must be set to mode 2 for this to work.

Nic.

[/quote]
You can also use these 'timed' parameters with an LTP fade time to fade in a shape.

Hope that helps.

Nic[/quote]

OK. So that's more or less the same as the "damped" effect on Hog desks? Or is it possible to to that on an Avo?

Regards

Yes, similar to hog.

This gets rid of the messy 'snap' to the start offset of a shape. The use of 'timed' and LTP fades was never documented.

The only other way to avoid a 'snap' is to set the size to timed and manually fade the shape in and out on mode 2 - though this is a compromise.

I don't recommend setting a LTP fade time and using the fader on mode 2 at the same time!

Best regards,

Nic.