Pearl 2008 Palettes

[CJ]

Hi,
I am an infrequent Avo user but usually have enough experience to get by.
Yesterday i had an issue that i was unable to get around.
I was using a Pearl 2008(s/w version unknown currently) and some Robe LED 600 wash fixtures in Mode 1.
In this mode the fixtures are split so that you can control each individual ring of the LED fixture which gives you Red/Green/Blue/White for each indivdual ring so you should in theory be able to create colour palettes for each section of the fixture.
The problem was i was unable to correctly store the palettes so i could get
white section 1,white section 2,white section 3....each time recorded a new palette in either by fixture or by channel it would directly alter the previous or next palette.
Can anyone suggest a good method of doing this or is this not possible with multipart LED fixtures.

Kind Regards Cormac

[niclights]

I can't think of any reason this wouldn't work. Palettes on Classic do not have any record mode options, it is always 'programmer by channel' masked according to attribute bank/focus mask.

Try again ensuring only the specific attribute is in the programmer when you record.