The Avolites Discussion Forum

Titan One software behaved normally at first, but stopped outputting any DMX (or correct DMX) soon after installation (on a new Windows 10 PC).

I've gone through the recommended uninstall and reinstall, and other suggestions from the forum. I can get DMX output from the Avolites USB diagnostic software using the DMX test, but none from the actual Titan One software.

Any other suggestions?

I also have drivers for an ETC DMX gadget installed on the same PC, in case that's a concern.

Thanks, Owen

Is DMX Output A assigned to Line 1 in DMX Setting which can be found in System mode? Also check that DMX output is enabled in the Avo menu and for the Expert DMX module - the cog icon next to it in DMX Settings.