The Avolites Discussion Forum

Hello everybody .
I come to you, because after much research I have not found solutions ....
I just update the version 10 software and since I can not hold two take shape without two seconds of latency.
Same problem with swop boutton more I chained the more latency increases.

Avolite recommends 4Gb RAM and I have a I3 8Gb.

I tried to boost the USB port, and RAM increases granted to Titan.

I never had this problem before since version 6.1 may be that other people have already experienced this problem.

thanks in advance!!

Same here lag non stop in V10. I reverted to v9.1 and all lag is gone. V10 I guess does not like T1.

Do you have an solid state drive (SSD) in your computer? This is now a requirement for v10 and without it you may experience performance issues.

thanks for you answer .

i tryed with a better computer and no one problem..
So i go buy a new computer ....