Changing Location of fixture as group
Moderator: Moderators
- zahoorjury
- Posts: 145
- Joined: 23 Aug 2007, 00:20
- Location: karachi,pakistan
Changing Location of fixture as group
Normally when patch fixtures the capture shows all in front of back wall, how can change the group position to left or right sides of the stage ( I know solo one by one can be adjust )
- Attachments
-
- image.jpeg (134.69 KiB) Viewed 3155 times
Re: Changing Location of fixture as group
With the wheels set to Visualiser and the group selected, toggle the Position attribute bank to show Rotate Y on the centre wheel and change the value to 90 or 270 degrees. Then toggle back to Position and change the X, Y and Z as required. Note that you can use Fan when changing Position to spread out your fixtures.
- zahoorjury
- Posts: 145
- Joined: 23 Aug 2007, 00:20
- Location: karachi,pakistan
Re: Changing Location of fixture as group
Hi , sorry for asking too much , what is the quickest and easiest way to arrange fixtures location in ROUND shape in Capture,
Thanks in advance
Thanks in advance
- Attachments
-
- IMG_0566.JPG (118.29 KiB) Viewed 3141 times
Re: Changing Location of fixture as group
Unfortunately I don't think there is any particularly easy way at the moment.
I would probably split into two groups, position as two lines one above the other, then use fan (set to 'pull middle') to get a diamond shape. After that it will need manually tweaking to make a circle, probably by moving as pairs if there are an even number.
I would probably split into two groups, position as two lines one above the other, then use fan (set to 'pull middle') to get a diamond shape. After that it will need manually tweaking to make a circle, probably by moving as pairs if there are an even number.
Who is online
Users browsing this forum: No registered users and 1 guest