The Avolites Discussion Forum

Hello community,

I have a small beam fixture that has 2 dimmers. One for the main light and one for some led tubes around it. Is there a way to make a personality with 2 HTP channels(it's possible for .R20 personality at least)?

Best regards,
Peri_95

The only way to achieve this is to use subfixtures (cells).

You can export R20 files with multiple HTP channels however D4 files do not support this. Before exporting R20 files go to the Wheel Mapping tab and select Classic Pearl, the properties for the selected attribute are shown on the bottom left and the channel type can be selected from a drop-down list.

Apologies. I misunderstood and thought you were asking if it was possible in Titan. Sorry for any confusion!

Hello everybody,

Yes, i asked for Titan. Thank you, I 'll try to do it like that then.

Thanks ans best regards