Took off the heatsink and there was a piece of plastic in between the CPU and the heatsink.

Put some new coolingpaste between it and it runs a normal temperature.

Now to get our iiyama prolite t1731sr working again.

Just looked at the specs of the CPU and it can get to 100 degrees. But tomorrow I'm going to look at the heatsink. Replace the cooling past and see if it gets better.

Now running a show, when it uses 30% of it's CPU it sometimes gets to 70 degrees, and in idle about 58

Yep, fan is working properly. It's now running in Titan and getting about 60 degrees, the fan is turning at about 6300 rpm.

I installed speedfan to check the temperature and it's running at 53 degrees.

I think the calibration in bios for the temperature sensor is wrong. Because in the bios it says it's almost 70 degrees.

I checked in bios and the usb keyboard support is on.

The healthcheck of mine Expert also says that the usb panel firmware has to updated.

Also the mousepad on my key isn't working anymore.

After updating the bios the console shuts itself down because it's getting to hot.

Before the bios update there was no problem with the console.

Does anyone else have problems with this?

Hello,

The power supply of a Pearl 2004 console is blown up by a high voltage peak.

Now I looking for an new one to see if the rest of the console got damaged.

Is there anyone that can help me with this?

Greetings,

Bram Boot

I've recreated the manual cross fade with the raw dmx values on my pc in the editor and there it does the same. It doesn't go all the way or over the values I specify (73 and 50).

The [kill at zero] does the trick, thanks.

The Raw values work fine if you use the go button, but I want it on a manual cross fade. Because it's a cue between open shutter and 100% strobe. If I do that, it doesn't go to wright values most of the times. Thanks for the help about cue-lists. I'm going to try it today, the [kill at zero]. If tha...

I wonder if you have misunderstood the manual? There is no automatic kill after changing page that I know of. If you can find the section please let me know the page so I can check. I actually refer to 2 things in the manual on page 68. In 6.2.3 it says to lower and raise the fader. It works for ch...

Well, I had had 3 cue-lists under 3 playback faders on one page and 3 other cue-list under the same faders a second page. The manual say if the cue has a fade of 2 seconds it will release automatically after changing page or else close the fader and reopen it, it doesn't release the cue-lists from t...

I had the same problem on the Tiger Touch today. I hope that in the next version of Titan cue lists will release automatically.